RTS KP95 Guida di Installazione Scaricare il pdf (Pagina 9)

CHAPTER 1

Introduction and Installation

NOTICE: These servicing instructions are for use by qualified personnel only. To avoid electric shock do not perform any

servicing other than that contained in the Operating Instructions unless you are qualified to do so.

ADAM CS Front Panel

There are 10 card slots in the front panel. Starting from the left side, slots 1 through 8 are for Audio Input/Output (AIO) Cards.

Slots 9 and 10 are for main and backup Master Controller Cards.

The two large bays at the right side of the front panel contain main and backup power supplies. These power supplies are

mounted in shuttles which may be pulled out for quick access/replacement. The power supplies are designed for automatic

switch-over in the event of a power supply failure. There is an audible alarm for indication of power supply failure. An alarm

override switch lets the user turn off the audible alarm after notification, allowing the affected power supply to be replaced at a

later time.

ADAM CS Back Panel

There are two fused AC Power connectors with ON/OFF switches. The AC1 connector porvides power to the PS1 power

supply. The AC2 connector provides power to the PS2 power supply.

Four AC-powered fans along the top of the back panel provide cooling for the power supplies and circuit cards. Either AC ON/

OFF switch will activate the cooling fans and the associated power supply.

The bottom half of the back panel is reserved for the connector panel. Three styles of connector panels are available, offering a

choice of intercom port connectors:

RJ-11, 9-pin male D-sub, or 50-pin Telco. At the left side of the connector panel are four additional connectors:

J900 DE-9S female) connector for RS232 connection to a personal computer.

J901 DE-9S Connector for RS485/232 connection to an RTS Trunking System

J902 DE-9S Connector for RS485/232 connection of Program Assign Panels, LCP-102 Level

Control Panels, and UIO-256 Universal Input/Output Frames

J903 DB-25S (female) connector for general purpose interface. Provides eight, open-collector

digital inputs and eight relay outputs.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

Nessun commento

RTS KP95 Guida di Installazione Pagina 9