RTS KP95 Guida di Installazione Scaricare il pdf (Pagina 11)

Power Supply Removal /Installation

Master Controller Notes

•

As shipped from the factory, all master controller card DIP switches are set for default operation. These settings will be

satisfactory for most applications. Optional settings are summarized in Table 2, “ADAM CS Master Controller Card DIP

Switch Settings (S1),” on page 19. If you change any settings, make sure both the main and backup master controller cards

are set the same.

Power Supply Removal /Installation

To install a power supply, insert the metal flanges on the top and bottom of the shuttle into the upper and lower guides in the

frame. Push the shuttle into the slot until it is firmly seated. Tighten the captive screws.

AC Power Connection

1. Place the AC switches on the back panel of the ADAM CS frame in the OFF (O) position.

2. Place the power supply on/off switch on the front of each power supply in the OFF (o) position.

3. Connect the AC power to both of the AC jacks on the back of the ADAM Frame. Connecting both AC inputs will insure

continued operation of the ADAM CS Frame in the event that one power supply fails. If desired, two separate AC power

phases may be connected. This will protect not only against a power supply failure, but also against a loss of power to one

phase.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 33 34

Nessun commento

RTS KP95 Guida di Installazione Pagina 11