RTS Cstrunk Specifiche Pagina 54
- Pagina / 104
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
48
Service Menu, Sidetone
Sidetone lets you adjust the level of you own voice heard in the headphones when using a headset. Most people prefer some
amount of sidetone to overcome the muffled sensation when talking, especially when wearing a full-muff headset. The
maximum level is 0dB.
Service Menu, Snoop Tally
Snoop Tallies provide an indication to keypanel users that somebody is listening to them.
NOTE: To use Snoop Tallies, the keypanel must be woring in Hot Mic (USM) Mode. This is available only on the KP 32
Family of keypanels.
To configure snoop tally, do the following:
1. Select Snoop Tally, then tap PGM.
→
No Chime (default) appears in the display window.
↑↑
toggles between No Chime and Chime.
2. Tap PGM.
Snoop Tally is configured.
3. Tap CLR to exit.
4. Run Service Menu, Save Cfg. to store the Snoop Tally setting.
Service Menu, Test Panel
Test Panel lets you check the operation of all key and displays.
1. All alpha-numeric displays show a % symbol. Pressing down on any key (except the Headset / Vol. Sel. key) will
cause OK to display. This verifies operation of the key. Tapping up or down on the Headset / Vol. Sel. key will cause
the display to cycle through the available selections.
2. If latching is enabled, tapping up or down on any intercom key, or the Call waiting key, will cause the corresponding
red LED to light. This verifies latching operation and also that the each red LED is OK.
3. Holding any key in the up or down position will cause the corresponding green LED to light. This verifies operation
of the green LEDs.
4. Tapping any keypad button (except CLR) will cause the keypad button name to appear in the call waiting window.
This verifies operation of the keypad buttons.
5. Tap CLR to quit.
Service Menu, Tone Gen
Tone Gen turns the KP-632 tone generator on or off. You can use the tone generator to check the audio path from the keypanel
to the matrix and back.
> Tap CLR to quit.
NOTE: The microphone is muted when the tone generator is active.
- USER INSTRUCTIONS 1
- Contents 3
- Introduction 9
- GPI Connector Module 10
- EKP-632 Expansion Keypanel 11
- LCP-632 Level Control Panel 11
- MCP-90 Panel Microphone 12
- Headsets 12
- Installation 13
- Address Switch Setting 14
- Address Setting for Zeus 15
- Address Setting for ADAM CS 15
- Connections 16
- Power Supply Connector 17
- Headset Connector 17
- Panel Microphone Connector 18
- Basic Operation 19
- Intercom Keys and Displays 20
- Listen LED Indication 21
- Intercom Key Operation 22
- Muting the Microphone 23
- Call Waiting Operation 24
- Telephone Operation 25
- KP9X Redial Sequence 26
- KP9X Autodial Sequences 26
- Manual Dialing 27
- Autodial 28
- Display Panel ID 29
- > Tap CLR to quit 29
- 1. Tap the E-PNL key 32
- 3. Tap the PGM key 32
- • Tap COPY 35
- Clearing a Key Assignment 35
- KP-632 Menu System 37
- Menu System, Key Assign Menu 39
- Key Assign Menu, Matrix 40
- Key Assign Menu, Pt-to-Pt 40
- Key Assign Menu, Party Line 40
- Key Option Menu 43
- Key Option Menu, Key Groups 44
- Key Option Menu, Solo 44
- RVON Conn. Menu 45
- Service Menu 45
- Service Menu, Baud Rate 46
- Service Menu, Dim 46
- Service Menu, Disply Dim 46
- Service Menu, Hdst Sel 48
- Service Menu, LCD Bright 48
- Service Menu, Matrix Out 51
- Service Menu, Mic Select 51
- Service Menu, Min Volume 51
- Service Menu, Mod Assign 51
- Service Menu, Output Level 52
- Service Menu, Reset Cfg 53
- Service Menu, Save Cfg 53
- Service Menu, Scr Saver 53
- Service Menu, Sidetone 54
- Service Menu, Snoop Tally 54
- Service Menu, Test Panel 54
- Service Menu, Tone Gen 54
- Specifications 55
- Speaker Amplifier and Speaker 56
- KP9x Display Sequences 63
- KP9x Setup Page Assignment 64
- KP9x Phone Operation 65
- Menu Access 67
- Menu List 68
- Mode 2 Operation 69
- Glossary 71
- Features 77
- Dip Switches 79
- Addresses and the RVON-1 82
- Top Level Menu, Rvon Conn 84
- Basic Network Configuration 87
- Wide Area Network 89
- TABLE 4. Packet Translation 90
- TABLE 5. Packet Translation 90
- IP Addresses 92
- Ping a Computer 93
- RVON Configuration 95
- Network Terminology 96
- • Backcard DB-9 J2 98
- Press Enter 100
- 3. Press Enter 101
Prodotti e manuali riguardandi Sistemi di interfono RTS Cstrunk
Sistemi di interfono RTS CIF-612 Specifiche
(72 pagine)
(72 pagine)
Sistemi di interfono RTS TR-240 Specifiche
(86 pagine)
(86 pagine)
Sistemi di interfono RTS BP300 Manuale Utente
(18 pagine)
(18 pagine)
Sistemi di interfono RTS TWI224 Manuale Utente
(39 pagine)
(39 pagine)
Sistemi di interfono RTS RVON-I/O Manuale Utente
(60 pagine)
(60 pagine)
Sistemi di interfono RTS TM-2000 Manuale Utente
(28 pagine)
(28 pagine)
Sistemi di interfono RTS XCP-24 Manuale di Servizio
(114 pagine)
(114 pagine)
Sistemi di interfono RTS MRT327 Manuale Utente
(12 pagine)
(12 pagine)
Sistemi di interfono RTS XCP-955 Manuale Utente
(49 pagine)
(49 pagine)
Sistemi di interfono RTS BP-325 Manuale Utente
(39 pagine)
(39 pagine)
Sistemi di interfono RTS XCP-ADAM-MC Specifiche
(19 pagine)
(19 pagine)
Sistemi di interfono RTS TR-240 Specifiche
(20 pagine)
(20 pagine)
© 2020, manymanuals.it. Tutti i diritti riservati | 0.023 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale